Warhead CNC Black Brushless Motor
You will need a 1.27mm Hex Key (available here for $0.99) for tightening the pinion gear
You will need a 1.27mm Hex Key (available here for $0.99) for tightening the pinion gear
You will need a 1.27mm Hex Key (available here for $0.99) for tightening the pinion gear
Warhead Industries CNC Black Brushless Motor. These brand new motors will revolutionize AEG performance. More torque, more speed, less heat, and less power than a traditional brushed motor. For use with 7.4V or 11.1V LiPo or Li-Ion batteries only. Compatible with all GATE, Jefftron, and Peruns mosfets, as well as stock trigger units. Drop-in fit for most AEGs.
CHOOSE YOUR SPEED
30K RPM
20,000 RPM (7.4V)
36K RPM
25,000 RPM (7.4V)
52K RPM
35,000 RPM (7.4V)
20K RPM
13,000 RPM (7.4V)
Available on Warhead Base Brushless Motor
PERFECT FOR A DIRECT SWAP WITH HIGH TORQUE 22TPA BRUSHED MOTORS
FEATURES
7075 ALUMINIUM HIGH QUALITY CASING
TOTAL CUSTOM IN-RUNNER DESIGN WITH MAXIMUM POWER AND TORQUE
HIGH TEMPERATURE RESISTANT QUALITY COPPER WINDINGS
HIGH QUALITY MAGNETS
HIGH PRECISION CNC CASING BACK PLATE COVERING ESC
BUILT IN ON-BOARD ESC WITH LOW VOLTAGE CUT-OFF AND OVER CURRENT DRAW TO PROTECT LIPO BATTERIES FROM OVER DISCHARGE
HIGHEST QUALITY REMOVABLE PINION GEAR FOR EASY SWITCH OUTS
FAQ
-
Brushless motors have higher performance in every way. More torque, higher speeds, less heat generated, less noise, longer lifespan, and less power consumption all at the same time.
-
No! All speeds share the same super high torque. The speed options are completely personal preference. This is another advantage over traditional brushed motors, where players usually have to find the right balance between speed and torque.
-
Yes! These motors were designed to be compatible with ANY mosfet. Note that a mosfet is not required and you may still use this motor using stock trigger contacts. Please refer to Warhead’s suggested mosfet settings.
-
They are a direct drop-in upgrade to your existing motor. Just plug the motor wires onto the tabs like normal and that’s it.
Warhead Brushless vs Brushed Motors
Using 11.1C 30C Lipo, 13:1 gearset, and M120 spring @ 2J
